Labconco ScrubAi Pipette Washer/Dryer 46120 Series - Manuel (Page 26)

Chapter 4: Using Your Washer/Dryer
Product Service 1-800-522-7658
22
22
The wash cycle can be terminated at any time by pressing and holding the
RUN/CANCEL button. This will cause the washer to drain and end the current
cycle.
Alarms
Throughout a wash cycle, there are several abnormal events that could occur. The
washer is programmed to monitor these occurrences and provide an alarm to alert
the operator. Information is shown on the display to identify the alarm situation.
The following messages may be displayed.
Lid Pause
This displays if the Clear Lid has been removed or not in position.
Operation of the wash cycle is delayed until the Clear Lid is replaced in
the correct position. Once replaced the wash cycle will resume where it
was interrupted.
Fault-Drain
This displays during the drain cycle if there is a No Water or Water Found
fault. Once the drain is complete one of two defaults will display as
follows.
Fault-No Water
This displays if a water fill is inadequate. The washer will cancel the
cycle and drain any water that is in the washer. The alarm is canceled by
pressing RUN/CANCEL. See Chapter 7: Troubleshooting – Washer will
not fill.
Fault- Water Found
This displays if water is detected in the base of the Washer/Dryer. Water
fill valves will be closed and the washer will cancel the cycle and drain
any water that is in the washer. The alarm is canceled by pressing
RUN/CANCEL. See Chapter 7: Troubleshooting – Washer leaks.
Fault-Temp Fail
This displays on heated models only if the temperature sensor is not
working properly. The washer will stop the cycle. The alarm is canceled
by pressing correcting the fault See Chapter 7: Troubleshooting –
Temperature sensor failure.