Labconco ScrubAi Pipette Washer/Dryer 46120 Series - Manuel (Page 22)

Chapter 4: Using Your Washer/Dryer
Product Service 1-800-522-7658
18
18
FOR PIPETTES WITH BULB
DIAMETERS GREATER THAN .70
(17.8mm) BUT LESS THAN .98
(24.9mm), STEM DIAMETERS
LESS THAN .34 (8.6mm) AND TIP
TO BULB LENGTH GREATER
THAN 7.25 (184.2mm), UNIT
CAPACITY IS 20. USE THE
SMALLER HOLES IN THE TUBE
GUIDE ASSEMBLY AS SHOWN.
FOR PIPETTE WITH BULB
DIAMETERS LESS THAN .49
(12.4mm) STEM DIAMETERS
LESS THAN .30 (7.6mm) AND
TIP TO BULB LENGTH
GREATER THAN 7.25
(184.2mm) THE UNIT
CAPCITY IS 60. USE ANY
HOLE SIZE IN THE TUBE
GUIDE ASSEMBLY.
PIPETTES SHOWN
INSTALLED IN TUBE
GUIDE ASSEMBLY
WITH TIPS ENGAGED
WITH SEAL
TIP TO
BULB DIM
BULB
DIAMETER
SHORTER PIPETTE
W/ TIP TO BULB
LENGTH LESS
THAN 7.25 (184.2mm)
FOR PIPETTES WITH BULB
DIAMETERS GREATER THAN .95
(24.1mm) BUT LESS THAN .34
(33mm), STEM DIAMETERS LESS
THAN .34 (8.6mm) AND TIP TO
BULB LENGTH GREATER THAN
7.25 (184.2mm) UNIT CAPACITY
IS 12. USE THE SMALLER HOLES
IN THE TUBE GUIDE ASSEMBLY
AS SHOWN.
FOR PIPETTES WITH BULB
DIAMETERS GREATER THAN
.49 (12.4mm) BUT LESS THAN
.70(17.1mm), STEM
DIAMETERS LESS THAN .340
(8.6mm) AND TIP TO BULB
LENGTH GREATER THAN 7.25
(184.2mm) UNIT CAPACITY IS
36. USE THE SMALLER HOLES
IN THE TUBE GUIDE
ASSEMBLY
PIPETTES SHOWN
INSTALLED IN TUBE
GUIDE ASSEMBLY
WITH TIPS ENGAGED
WITH SEAL
TIP TO
BULB DIM
BULB
DIAMETER
SHORTER PIPETTE
W/ TIP TO BULB
LENGTH LESS
THAN 7.25 (184.2mm)
FOR PIPETTES WITH BULB
DIAMETERS LESS THAN .45
(11.4mm) AND TIP TO BULB
LENGTH GREATER THAN 4.6
(116.8mm) OR STEM
DIAMETER LESS THAN .185
(4.7mm) THE UNIT CAPACITY
IS 24 USE THE LARGER
HOLES IN THE TUBE GUIDE
ASSEMBLY
To load the Washer/Dryer:
To load a pipette, insert the tapered end through the Tube Guide Assembly as
straight as possible. Engage the rubber seal hole in the bottom of the tank. Insert
the pipette into the hole by twisting the pipette slightly while pressing down. Press
with enough force to seal the tip of the pipette in the hole of the rubber seal. Do
not force the pipette beyond the tapered portion of the tip.