Sony MDS-JE530 - Manuel (Page 18)

Recording Tips
When INPUT is set to 0PT1 or 0PT2
The digital signal input from the DlCdTAL IN (OPTI
or OPT2) connector is output to the DICilTAL OUT
connector after passing through the sampling rate
converter, and then to the LINE (ANALOG) OUT jacks
and PHONES jack after D/A conversion. DA"
appears in the display at this time.
Erasing blank portions automatically
(Smart Space/Auto Cut)
The deck can he set to automatically erase any blanks that
are produced when the signal is interrupted during
recording. The function which acti\ ates (Smart Space or
Auto Cut) depends on the length of the interruption, as
described below.
Smart Space
If the signal is interrupted for less than 30 seconds. Smart
Space replaces the blank portion with a blank space of
about three seconds, then continues the recording. "Smart
Space" appears in the display during this time.
3 Turn AMS (or press repeatedly) to select
the setting, then press AMS or YES.
To Select
Turn
Olì
Siiìiìrt Space and Auto Cut S.Space On (factorv
sotting)
Turn off Smart Space and Auto Cut S.Space Off
4 Press MENU/NO.
Notes
• If voll start recording with no signal input. Smart Space and
Auto Cut will not operate regardless of the setting.
• Smart Space does not affect the order of the track numbers
being recorded, even if the blank space occurs in the middle of
a track.
• Auto Cut is automaticallv turned on or off in tandem with
Smart Space.
• If you turn off the deck or disconnect the AC power cord, the
deck will store the last setting ("S.Space On" or "S.Space Off")
and recall it the next time vou turn on the deck.
Auto Cut
If the signal is interrupted for about 30 seconds. Auto Cut
replaces the blank portion with a blank space of about
three seconds, then pauses the recording. "Auto Cut"
appears in the display during this time.
Do the procedure below to turn Smart Space and Auto
Cut on or off.
1 While the deck is stopped, press MENU/NO twice.
"Setup Menu" appears in the display.
2 Turn AMS (or press •◄◄/►►I repeatedly) until
"S.Space On" appears, then press AMS or YES.
1 8 ^