Header installation for the floor-mounted hoods – Labconco Protector XL Floor-Mounted (Walk-In) Laboratory Fume Hoods 1128 Series Manuel d'utilisation
Page 27
Chapter 3: Getting Started
Product Service 1-800-522-7658
23
Original instructions
Header Installation for the Floor-Mounted
Hoods
The header is shipped separately in its protective packaging. To install, the header
is fastened to the corner covers by four #12 screws. Reach behind the corner posts
from the side and install the screws to support the header. See Figure 3-8.
Figure 3-8
Front Panel Installation for the Floor-
Mounted Hoods
The hood front panel(s) is shipped separately and is protected. To install each
panel, hang the two plastic cylinders on the backside of the front panel over the
corner posts and center support (10', 12', 16' models). The bottom of the front
panel will then slip behind the header once it has been properly secured at the top.
See Figure 3-3 and Figure 3-8.
#12 Screws
Corner Post
Header
Front Panel