Preparing the commander, Setting up the commander, 1 remove the touch pen – Sony RM-TP501E Manuel d'utilisation
Page 6: 2 turn contrast to adjust brightness of the lcd, 3 adjust the position of the touch panel's lcd
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
Preparing the Commander
Setting up the commander
Ploiiso bo suro to onrr\ out tho following 1 to 5 procodures
for prop.iiMfion of flio commander.
Tho commander's panel is touch sensitix e and can he
operated h\- simph' touching it.
Remove the touch pen.
When returning the touch pen, always slide it in tip
Use only the touch pen provided with this unit or the soft tip
of your finger to operate the touch panel. Using a
commercially available writing utensils may damage the
panel and make correct operation impossible. If the tip of the
touch pen is damaged, or the touch pen is lost, please consult
your nearest Sony dealer. '
Turn CONTRAST to adjust brightness of the LCD.
Touch panel adjustment
Adjust the position of the touch panel's LCD.
Touch the center of each of flie 4 dots with the touch
pen. When all 4 dots ha\ e been touched "Adjusted"
appears, a buzzer sounds, and the initial
communication screen appears.
Touch the 4 dots with the touch pen.
Touch panel adjustment must be carried out for proper panel
operation. If used without adjustment, the "Touch Panel
Adjustment" screen appears each time the LCD lights up.
Press ® on the amplifier to turn on the amplifier.
Point the commander's transmitter/receiver section
toward the amplifier, and touch OK.
Once initial commuTiication with the amplifier has
been^stablished, fhe commander is ready to operate
Communicating with system.