Registering the connected component, To stop registration at any time, I - i – Sony RM-TP501E Manuel d'utilisation
Page 20: Adjusting the commander's operating environment
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

Adjusting the Commander's Operating Environment
o
■ o
0
3
Registering the connected component
TIu' tollou ing procodun.' lots \'ou setup the component
commander to operate tire components connected to the
ainplitier.
When carrying out this operation, make sure that the amplifier's
power is on, and be sure to point the commander's transmitter/
receiver section toward the amplifier.
1
Touch SETUP.
The SETUP screen appears.
2
Touch FUNCTION&USER IR.
The FUNCTION&USER IR screen appears.
FUNCTION&USER IR
I - I
VIDEOl :
Sony VTR3
VIDE02:
Sony VTR2
VIDE03:
JVC VTRl
DVD/LD:
Pioneer DVD
TV/DBS:
Sony DSS
I - I
3
Select the function that you wish to register (Ex:
VCR).
To display other items, use the JOG DIAL or touch
A
or
T
to scroll through the list.
The FUNCTION&USER IR:CATEGORY screen
appears.
^ FUNCTIONtiUSER IR: CATEGORY
LD
DVD
TV
DSS
CANCEL
4
Select the type of component connected (Ex: Sony
VTR1).
To display other items, use the JOG DIAL or touch
A
or
T
to scroll through the list.
The FUNCTION&USER IR:MAKER CODE screen
appears.
FUNCTIONEUSER IR; MAKER CODE
Sony VTRl
Sony VTR2
Sony VTR3
Panasonic VTRl
Panasonic VTR2
CANCEL
5
Touch the remote controller mode of the connected
component.
The component selected in steps 4 to 5 will be
registered at the function selected in step 3, and the
SETUP screen will reappear. A long beep sound is
emitted to indicate that registration was successful.
Operation is now possible from the FUNCTION
screen.
If a series of short beeps is emitted, redo the
registration procedure. If this occurs, make sure the
amplifier is turned on and that the commander is
pointing toward the amplifier during operation.
To stop registration at any time
Touch EXIT during step 2 or touch CANCEL during steps 3 to 5.
Notes
• All icons may not be displayed when registering components
made by certain manufacturers.
• Some icons may not function even though they are displayed
when registering components made by certain manufacturers.
2QGB