Sony MDS-JE630 - Manuel (Page 28)

Creating Your Own Program
(Program piay)
To enter a track number over 25 ij
Use >25. For details, see page 25.
To check the total playing time of the program
Press LEVEL/DISPLAY/CHAR (or DISPLAY).
4 Repeat step 3 to enter other tracks.
The entered track is added to the location where the
"0" flashes.
Each time you enter a track, the total program time
appears in the display.
5 Press YES.
“Complete!!" appears and the program is completed.
6 Press PLAY MODE repeatedly (or PROGRAM once)
until "PROGRAM" lights up in the display.
7 Press O.
Program Play starts.
To stop Program Play
Press ■.
To resume normal play
Press PLAY MODE repeatedly (or CONTINUE once) until
"PROtiRAM" turns off.
Q The program remains even after Program Play ends or is
stopped
Press I> to play the program again.
Notes
• If you turn off the deck or disconnect the AC power cord, the
program will be lost.
• The display shows "-----m - - s" when the total playing time of
the program exceeds 199 minutes.
• "ProgramFull!" appears when you try to program 26th track.
Changing the contents of the program
While the deck is stopped and "PRCIGRAM" lights up, do
steps 1 and 2 of "Programming the tracks" on page 27,
followed by one of the procedures below:
To Do the following:
Erase a track Press ◄◄/►► repeatedly until the
number of the unwanted track flashes,
then press CLEAR.
Erase all tracks Press CLEAR repeatedly until alt the track
numbers disappear.
Add a track at the
beginning of the
program
Press repeatedly until "0" flashes
before the first track number, then do steps
3 to 5 of "Programming the tracks" on
pages 27 and 28.
Add a track in the
middle of the '
program Press repeatedly until the track
number which will precede the new track
flashes. Press AMS to display flashing
"0, " then do steps 3 to 5 of "Programming
the tracks" on pages 27 and 28.
Add a track to the
end of the program Press ►► repeatedly until "0" flashes
after the last track number, then do steps
3 to 5 of "Programming the tracks" on
pages 27 and 28.
Replace a track Press repeatedly until the
number of the track to be changed flashes,
then do steps 3 to 5 of "Programming the
tracks" on pages 27 and 28.
Checking the contents of the program
While the deck is stopped and "PROGRAM" lights up,
press LEVEL/DISPLAY/CHAR (or DISPLAY) repeatedly.
The first several tracks in the program appear in the
display. To see the rest of the program, turn AMS (or
press /►►! repeatedly).
28^