Pioneer X-NM1 - Manuel (Page 33)

33
En
8 Using the timer
English
7 Switch the system into standby mode
before timer recording starts.
The record timer indicator (
¶) in the display indicates
that the record timer is set.
After the recording has finished, the record timer is
automatically canceled. See the following section,
Activating/deactivating the timers, to cancel before
recording, or to recall the timer settings after recording
has finished.
• If the wake up timer has been set, see the following
section, Activating/deactivating the timers, for
limitations with using the timers concurrently.
• After setting the timer, playback starts according to
the most recent changes to the tape direction.
• If the AC power is cut (blackout, accidentally
unplugging the power cord), the system will return to
the 12:00 clock display and both the timer and clock will
have to be set again for the timer to work.
• The timer won’t work if the clock isn’t set!
Activating/deactivating the timers
You might choose to cancel the wake up timer, but keep
the settings for a later time. You can also set the record
timer and still keep your wake up timer settings.
1 Switch the system to standby.
2 Press TIMER repeatedly to cycle through
the timer options.
Choose
TIMER OFF to deactivate all timer settings. To
reset the wake up timer, or the record timer (or both),
select the corresponding
TIMER CHECK option.
TIMER CHECK
TIMER CHECK
TIMER CHECK
TIMER OFF
Wake up timer settings
( indicator is shown)
Record timer settings
(
¶ indicator is shown)
Both wake up ( ) and
record timer (
¶) settings *
Timer set to off
(both and
¶ disappear)
* When the wake up and record timers are both set,
make sure the end time of one timer does not overlap
with the start time of the other. Leave at least a minute
between the two settings (see below).
8:00 8:30 8:00 8:30
8:30 9:00 8:31 9:00