Pioneer X-NM1 - Manuel (Page 17)

17
En
4 Getting Started
English
Setting the reverse mode
The tape deck can play both sides of a tape without you
having to take the cassette out and turning it over by
hand.
The reverse mode tells the deck what to do when it
reaches the end of the tape on the side it's playing. There
are three modes: endless, reverse and one-way.
1 Press PLAY MODE (remote) repeatedly to
cycle through the reverse modes.
If you’re using the front panel, press
MENU / CLOCK
then select PLAY MODE (use
5 and ∞ to change the
displayed option in the menu; press ENTER to select).
Use
∞ and 5 to choose the reverse mode.
There are three reverse modes:
• – Plays one side then stops.
• – Stops after the end of the tape has been
reached in the reverse direction.
• – Plays the tape round and round
continuously.
In endless mode, the deck will only play the tape
through 16 times before it stops automatically.
Playing other connected
components
You may have connected various other components to
your system. These include a VCR, TV, MD player,
another tape, etc.
1 Press LINE.
2 Start playback on the connected
component.
You can adjust the sound level using the
VOLUME dial
on the main unit.
Using Sound Modes
Depending on what you are listening to, you may want
to change the sound quality to emphasize instruments
or vocals, or to create a live atmosphere.
• Press SOUND MODE (remote) repeatedly
to cycle through the Sound Modes.
The current Sound Mode is displayed, and with each
press you can select one of the four modes in the
following order:
• POP : High and low range sounds are emphasized
• VOCAL : Mid-range sounds are emphasized
• LIVE : The sound is given extra breadth to simulate a
live performance
• FLAT : No effect on the sound