Playing tapes, Getting started 4, Tape ms+o2 – Pioneer X-NM1 Manuel d'utilisation
Page 16
16
En
Getting Started
4
4 To skip back or forward a
track on the tape, press —
.
4 or ¢.+.
¢.+ searches for the next blank
space between tracks on the side
currently playing (in other words, to
the start of the next track), then
resumes playback.
— .
4 searches for the previous
blank space between tracks on the side
currently playing (in other words, to
the start of the current track), then
resumes playback.
By pressing —.
4 or ¢.+
more than once, the tape deck will skip
several tracks at once (up to a
maximum of 15). For example, press
¢.+ twice to skip forward two
tracks.
TAPE MS+O2
Track search is unlikely to work reliably
in the following cases:
• if the space between tracks is less
than about 4 seconds
• if the recording is particularly noisy
so the spaces are not recognized
• if the recording contains frequent
silences, such as a language study tape.
• if the recording contains sections of
very quiet material, such as some
classical music recordings
5 To rewind or fast forward the
tape, press — .
4 or
¢.+ with the tape
stopped.
6 To stop the tape, press
7.
On the top panel, press down the corner
of the cassette deck marked
PUSH
OPEN
(
0) to eject the tape.
Playing tapes
The tape deck lets you play or record
both sides of the tape without physically
taking it out and turning it over (auto-
reverse). If you’re planning on
recording right away, note that the tape
deck can only record on Type I
(normal) tapes. See Making tape
recordings on page 26 for more on
this.
1 Load a cassette tape
On the top panel, press down the corner
of the cassette deck marked
PUSH
OPEN
(
0) to open the cover and
insert a tape. Press down again to close.
2 Press TAPE (
23) to start
playback.
The side of the tape you'll hear is
whichever is facing toward you when
you load it. This is the 'forward' (
3)
direction, while the other side is
'reverse' (
2). The forward indicator is
shown in the display.
If there's already a tape in the deck,
then pressing the
TAPE
button—even
when the system is in standby mode—
will switch the system on and start the
tape playing.
3 To play the other side of the
tape, press TAPE (
23).
Each time you press
TAPE
(
23)
during playback, the other side of the
tape starts playing. Pressing
TAPE
(
23) when the tape is stopped starts
playback on the side it was playing
previously.
The current tape direction is indicated
in the display.
7
TAPE
PLAY
MODE
CD
This illustration is for
the UK and European
model only.