Kolpin 85200 – Universal Independent Rear Suspension Lockout - Manuel (Page 3)

Rev. 2
Polaris Mounting Instructions
1. Set the Backer Plate on the top side of the A-Arm. This plate is designed to fit with the holes
already in the A-Arm.
2. Take the A-Arm Bracket and place on the bottom side of the A-Arm. You should now be
“sandwiching” the Polaris A-Arm with the A-Arm Bracket and the Backer Plate. The A-Arm
Bracket can be cut down for fitment as you will notice in the picture below.
3. Bolt through the bottom of the A-Arm Brackets through the A-Arm and then up through the
Backer Plate using the Bolts, Washers and Nuts provided. The Washers and Nuts should be on
the Backer Plate so that the access threads won’t pick up debris. (See above Picture)
4. Next, pin in your Cross Bars to the A-Arm Bracket and then Bolt together in the middle of your
machine.
Kolpin Powersports, Inc.
205 N. Depot Street, Fox Lake, WI 53933
Phone #: 1-877-956-5746
www.kolpinpowersports.com
[email protected]
Backer Plate
A-Arm Bracket