Kolpin 26510 - Utility Gear Rail System Double Gun Boot Mount - Manuel

Rev. 2
26510 - Kolpin Utility Gear Rail System Double Gun Boot Mount
ITEM DESCRIPTION QTY
1 PLASTIC C‐CLAMP 1
2 FLAT BRACKET 1
3 WELDED BRACKET 1
4 STAR TURN KNOB 1
5 ¼” X 3/4” TRUSS HEAD BOLT 12
6 ¼” NYLOCK NUT 12
*THIS PRODUCT MUST BE USED IN CONJUNCTION WITH THE 26400 UTILITY GEAR RAIL SYSTEM
**THE BOOTTECTOR BRACKET ACCOMMODATES EITHER THE KOLPIN GUN BOOT 4 OR THE 6.0 (SOLD SEPERATELY)
MOUNTING INSTRUCTIONS:
1. Mount the flat bracket (item 2) to the C‐Clamp (item 1) making sure that the non‐threaded boss in
the C‐clamp is facing the same direction as the circle cut out on the flat bracket. Use the supplied (4)
¼” x ¾” Truss head bolts and ¼” Nylock Nuts to attach.
2. Mount the Welded Bracket (3) to the C‐Clamp provided with the 26400 Utility Gear Rail System in
the same configuration as Step 1. Use with the hardware that was supplied with the 26400.
3. Insert the Plastic Spline through the center hole cutout in the Flat Bracket and the Welded Bracket.
4. Place the Dust Cover on the back of the Spline. Using the (4) ¼” x ¾” Truss Head Bolts, insert
through the metal bracket and slide through the spline and Dust Cover. Secure the assembly with ¼”
lock nuts, and tighten.
5. Place the Boottector Sheath (7) on the Spline (9). Attach using the Turn Knob (11) provided.
6. The C‐Clamp will then slide onto the Aluminum Extrusion that is included in the 26400. Install the
star turn knob after the bracket is on the rail, adjust to position and tighten.
7. Place Gun Boot into Sheath and secure by using the 4 ‐ Pin Locks provided.
Kolpin Outdoors, Inc.
205 N. Depot Street, Fox Lake, WI 53933
Phone #: (877) 9KOLPIN or (920) 928-3118
www.kolpin.com [email protected]
ITEM DESCRIPTION QTY
7 BOOTTECTOR SHEATH (20035)* 2
8 DUST COVER 2
9 SPLINE 2
10 LOCK PINS 4
11 TURN KNOB 2
1
2
3
8 7
11
9