Kolpin 53560 - Stealth Heat Shield 2.0 - Manuel

Rev. 2
53560 Stealth Heat Shield 2.0
Heat Shield Mounting Instructions:
1. The heat shield attaches using the Mounting Band (2)
included in the box and the other Mounting Band that came
with your Kolpin Stealth Muffler. Use the 4 Carriage Bolts
(7) on each side (top and bottom) of the Mounting Bands as
shown in the picture.
2. The Kolpin Heat Shield has three slots (top and bottom) to make
it easier to center the shield over the muffler, no matter what position
your muffler is located. (1)
3. To make the installation easier, barely start the 4 nuts on the Carriage bolts. Once
all four are “connected,” position the Heat Shield where you want it and then tighten
the 4 nuts and bolts.
Kolpin Powersports, Inc.
205 N. Depot Street, Fox Lake, WI
Phone #: (877) 9KOLPIN or (920) 928-6514
www.kolpinpowersports.com [email protected]
NO. DESCRIPTION QTY.
1 Kolpin Heat Shield 1
2 Mounting Bands 2
3 Mounting Strap (8 Holes) 1
4 25mm R Shaped Mounting Strap 1
5 28mm R Shaped Mounting Strap 1
6 31mm R Shaped Mounting Strap 1
7 Black Carriage Bolt (8mm x 35.5mm) 2
8 Black Lock Washer (8mm) 2
9 Black Nut (8mm) 2
10 Hex Head Bolt (8mm x 36.25mm) 1
11 Flat Washer (8.75 mm) 1
12 Lock Washer (8mm) 1
13 Nut (8mm) 1
1
3
2
7
8 9
10
11
12
13
6
5
4