Kolpin 20072 - Gun Grips II Manuel d'utilisation

Composants Kolpin

Advertising
background image

Rev. 4

Kolpin Gun Grips II Mounting Instructions

20072










A


Parts List:



D






Mounting:

1. Locate the desired position on the ATV for the Gun Grip II.
2. Align the lower metal plate below the rack or tube so that the bolts slide through the holes of the

mounting base and the metal plate.

3. Mount the base to the ATV by using the provided ¼” bolts and nuts.
4. Place the Gun Grips II on the mounting base in the desired position.
5. Repeat this procedure for the other Gun Grip II.

NOTE: Gun Grips II are able to rotate in 15° increments. To rotate loosen the 3/8”
Philips head bolt at the center of the Gun Grips. Rotate Gun Grips to the desired position
and retighten the 3/8” Philips Head Bolt.
NOTE: The Gun Grips II is compatible with the Kolpin Bucket Hugger (91710). To
attach to the Kolpin Bucket Hugger, simply unscrew the 3/8” Philips Head Bolt from the
plastic base. On the Bucket Hugger there are two, 3/8” threaded inserts, molded into the
top side of the Bucket Hugger. Attach the Gun Grips to the flat area provided using the
3/8” Bolt that was removed. Tighten Securely.

Using the Gun Grips:

Place your desired item (not to be over 50lbs) inside the fingers of the Gun Grip II until a tight fit

is achieved. Use the rubber strap to secure the item in place by inserting the rubber strap into the slots
of the fingers. (You may choose to fasten the strap to other locations on the fingers.)

For additional assistance, please contact our customer service department at (877)-9KOLPIN or

[email protected]

Item Description

Quantity

A Grips

2

B

Mounting
Base 2

C Metal

Plate

2

D Rubber

Strap

2

E 1/4"

bolt

8

F 1/4"

nut

8

B

C

Advertising