Kolpin 20073 - UTV GUN RACK - Manuel

20073 UTV GUN RACK
UTV Gun Rack Assembly:
1. Attach the Forearm Holder to the insert tube using the 2 – 3/8” x 2.25” long bolts, and 4 flat
washers and 2 – 3/8” Nylock nut.
2. Attach the Gun Butt Holder to the Main Tube using the 2 – 3/8” x 3.25” long bolts, and 4 flat
washers and 2 – 3/8” Nylock nut.
3. Bolt the Steel Base Plate to the main tube. This may be set vertically or use the slots to custom fit
it to the angle of your UTV.
4. Slide the Insert Tube into the Main Tube and Bolt at height that is appropriate for you and your
gun. Note: UTV Gun Mount is able to be used in many different settings. Find which is the best
application for your guns and your UTV.
UTV Gun Rack Mounting:
1. Attach the UTV Gun Mount to the floor of your UTV using the 4 - 3/8” x 1.00” Bolts, 4 – 3/8”
Nylock nuts and 8 washers. Drilling is required.
CAUTION: Be sure that you are not drilling into anything under your floor as it may
void any warranty of your Vehicle. You may find it useful to pull up the flooring and
drill holes where you want the UTV Gun Mount to be at.
UTV Gun Rack Use:
• Place the Gun into the Kolpin UTV Gun Mount and secure with the Rubber strap.
• The UTV Gun Mount is designed to carry your Guns safely and securely from one destination to
the next.
CAUTION: Always make sure gun is unloaded and pointed in a safe direction before
traveling.
CAUTION: Check with local authorities to make sure you are able to travel with
uncased weapon.
Kolpin Powersports, Inc.
107 Industrial Drive, Fox Lake, WI
Phone #: (877) 9KOLPIN or (920) 928-6514
www.kolpinpowersports.com
[email protected]
Description Quantity
Forearm Holder 2
Rubber Strap 2
Steel Base Plate 2
Insert Tube 1
Main Tube 1
Gun Holder 1
3/8” x 1.00” Hex Head Bolt 4
3/8” x 2.25” Hex Head Bolt 5
3/8” x 3.25” Hex Head Bolt 2
3/8” Nylock Nut 11
3/8” Flat Washer 22
Manual 1