Kolpin 91875 – HEATED SEAT COVER - Manuel

Rev. 2
91875 – HEATED SEAT COVER
Mounting Specific Instructions:
Your Kolpin Heated Seat cover contains an automotive heating element with a built in temperature sensor
to prevent overheating. The heater element slides into a sewn pocket in the seat cover.
It is VERY IMPORTANT that before installing the seat cover on your machine that you do the following
step! The element utilizes an adhesive tape covered with a waxy paper to maintain positioning in the
cover-The paper must be removed and the element glued to the seat cover before operation! If the heating
element is not laid out completely flat and bonded to maintain this position, overheating can occur!
Without the adhesive holding the element in place, the heater can bunch up or overlap, resulting in
damage. Under no circumstances should the seat be operated without performing this step! Also, extra
seats on top of the heating unit can pose the same threats as the heating unit bunching up, causing the seat
to overheat. Please use CAUTION if using a Seat Box on the rear of your machine.
Once the heating element is installed properly in the seat cover, install the seat cover over your seat and
secure with the velcro straps. Excess velcro can be trimmed as necessary. Plug in the automotive style
adaptor into your power source or hardwire direct to your battery if desired. Use the rocker switch to turn
the unit on and off, remembering to turn the switch off when not in use!
For maximum longevity, use care when washing your ATV with the seat cover on. While the heating
element is waterproof, repeated exposure to moisture can affect the life of the heated seat cover. Your
heated seat cover is designed to last through years of service and will make cold riding that much more
enjoyable.
Thank you for purchasing Kolpin products!
Kolpin Outdoors, Inc.
205 N. Depot Street, Fox Lake, WI 53933
Phone #: (877) 9KOLPIN or (920) 928-3118
www.kolpinpowersports.com
[email protected]