Pioneer PDA-5003 - Manuel (Page 7)

4
En
Part Names and Functions
English
DIGITAL RGB
DVI-D
S-VIDEO
S-VIDEO
OUT R L
R L R L R L Y Pb/Cb Pr/Cr IN OUT
B R VD R L HD (H/V SYNC) G(ON SYNC)
INPUT3
INPUT3 INPUT4 INPUT5
VIDEO INPUT4 INPUT 3/4 ANALOG RGB AUDIO AUDIO
AUDIO AUDIO AUDIO COMPONENT
VIDEO VIDEO
INPUT5
IN
= - 0
L
POWER
OFF ON
AC IN
SPEAKER
8 Ω ~16Ω
+ –
~
^
! @
* (
#
& ) _
%
+
$
1 2 3 4 5 6
COMBINATION
IN OUT
RS-232C
R SPEAKER
8
Ω ~16Ω
+ –
7 8 9
ANALOG RGB IN
D-Sub
ANALOG RGB OUT
D-Sub AUDIO AUDIO AUDIO
INPUT1 INPUT2 OUTPUT
When installing PDA-5003
When installing PDA-5004
Part Names and Functions
Plasma Display Section
The plasma display is provided with 2 video input
connectors, 1 video output connector, audio input/output
jacks and speaker terminals.
When this video card is installed on a plasma display, an
additional three sets of video input connectors are provided
(total five), together with one additional video output
connector (total two). See the pages noted in parentheses
( ) or the plasma display’s Operating Instructions for details
regarding connections to the various jacks and connectors.
1
SPEAKER (R) terminal
For connection of an external right speaker.
Connect a speaker whose impedance is 8 -16
Ω.
2
COMBINATION IN/OUT
Never connect any component to these
connectors without first consulting your Pioneer
installation technician.
These connectors are used for plasma display setup
adjustments.
3
RS-232C
Never connect any component to this connector
without first consulting your Pioneer installation
technician.
This connector is used for plasma display setup
adjustments.
Connection panel
4
ANALOG RGB IN (INPUT1) (mini D-sub 15 pin)
For connecting components equipped with RGB
outputs jacks, such as a personal computer or external
RGB decoder; or components equipped with
component output jacks, such as a DVD recorder.
Make sure that the connection made corresponds to
the format of the signal output from the connected
component (pages 7 to 10).
5
ANALOG RGB OUT (INPUT1) (mini D-sub 15 pin)
Use the ANALOG RGB OUT (INPUT1) connector to
output the video signal to an external monitor or other
component.
Note: The video signal will not be output from the ANALOG
RGB OUT (INPUT1) connector when the main power of this
display is off or in standby mode (page 10).
6
AUDIO (INPUT1) (Stereo mini jack)
Use to obtain sound when INPUT1 is selected. Connect
this jack to the audio output connector of the device
connected to the plasma display’s INPUT1 (page 15).
7
DIGITAL RGB (INPUT2) (DVI-D jack)
Use to connect a computer.
Note: This unit does not support the display of
copyguard-protected video signals (page 13).
Illustration depicts PDP-504CMX/
PDP-50MXE1/PDP-50MXE1-S model.