Pioneer PDA-5003 - Manuel (Page 11)

8
En
English
Installation and Connections
Installation and Connections
Connection to INPUT1 or INPUT5
■ When using PDA-5003
Connection to AV components
Connection to AV component equipped with
component video jacks
Make component video connections for AV components
equipped with component video jacks.
When connecting to ANALOG RGB IN (INPUT1)
ANALOG RGB IN
D-Sub
ANALOG RGB OUT
D-Sub AUDIO
IN
INPUT1
On-screen setup is necessary after connection.
Please see pages 18 to 20.
When connecting to ANALOG RGB (INPUT5)
B R VD HD (H/V SYNC) G(ON SYNC)
ANALOG RGB INPUT5
Connect the Y signal to the G jack, the P B /C B signal to the
B jack, and the P R /C R signal to the R jack.
On-screen setup is necessary after connection.
Please see pages 18 to 20.
INPUT5 jacks are all BNC jacks.
If necessary, use commercially available BNC/pin-plug
conversion adapters to make connections.
Note
The plasma display and this Video Card are designed to support
component video signals with standard, stable signal levels and
sync signals. As a result, some image disruption may be
generated during use of various special trick play functions on
video components.
■ When using PDA-5004
Connection to AV components
Connection to AV component equipped with
component video jacks
Make component video connections for AV components
equipped with component video jacks.
When connecting to ANALOG RGB IN (INPUT1)
ANALOG RGB IN
D-Sub
ANALOG RGB OUT
D-Sub AUDIO
IN
INPUT1
On-screen setup is necessary after connection.
Please see pages 18 to 20.
: Connect to this jack.
Note
When making connections to INPUT1, please refer to the plasma
display’s Operating Instructions.
See Appendixes 1 and 2 (pages 43 to 45) for
information regarding signals and display formats
supported by INPUT1.
INPUT5
jack Y
Output source
Video component/
personal
computer (PC)
with RGB output
G ON SYNC
Video component
with component
video output
Y
Pb/Cb
B
Pb/Cb
Pr/Cr
R
Pr/Cr