Pioneer PDA-5003 - Manuel (Page 16)

13
En
Installation and Connections
English
Installation and Connections
Personal computer
Connection to INPUT2
A computer equipped with DVI output (digital RGB signal)
can be connected to the plasma display’s DVI connector.
DIGITAL RGB
DVI-D
AUDIO
INPUT2
On-screen setup is necessary after connection.
Please see pages 18 to 20.
Notes
¶ Use a DVI-D 24-pin (digital only) cable for the connection.
¶ This unit does not support the display of copyguard-
protected video signals.
NOTICE
¶ INPUT2 is compatible with Microsoft’s Plug & Play (VESA DDC
2B).
¶ For the screen sizes and input signals that INPUT2 is
compatible with, please refer to the plasma display’s Operating
Instructions.
Connection to INPUT3
Connect an AV component that has S-video output jack to
the video card’s S-VIDEO (INPUT3) jack.
S-VIDEO INPUT3
AV component
AV component
To a monitor or a
recording device
Connection to INPUT4
Connect an AV component that has a video output jack to
the video card’s INPUT4 jack. The VIDEO OUT (INPUT4)
jack can be used to output the video signal to a separate
monitor, recording device or other component with video
input capability.
Note
A video signal will not be output from the VIDEO OUT (INPUT4)
jack when the main power of this display is off or in standby
mode.
[When using PDA-5003]
OUT
VIDEO INPUT4
IN
[When using PDA-5004]
IN OUT
INPUT4 VIDEO
Signals to the INPUT3 and INPUT4 jacks are all
compatible with the following TV systems: NTSC, PAL,
SECAM, 4.43NTSC, PAL M and PAL N. For details,
please refer to “Setting the COLOR SYSTEM” on page
39.
AV component
To a monitor or a
recording device