Installation and connections, Connection of composite sync analog rgb source – Pioneer PDA-5003 Manuel d'utilisation

Page 15

Advertising
background image

12

En

English

Installation and Connections

When connecting to COMPONENT VIDEO (INPUT5)

[Connections for PDA-5004]

Y

Pb/Cb

Pr/Cr

INPUT5

COMPONENT
VIDEO

On-screen setup is necessary after connection.
Please see pages 18 to 20.

Connection of composite SYNC analog RGB
source

Make composite SYNC connections for a personal
computer with output that has the vertical
synchronization signal layered on top of the horizontal
synchronization signal.

When connecting to ANALOG RGB IN (INPUT1)

ANALOG RGB IN

D-Sub

ANALOG RGB OUT

D-Sub

AUDIO

INPUT1

On-screen setup is necessary after connection.
Please see pages 18 to 20.

Installation and Connections

When connecting to ANALOG RGB (INPUT5)

[Connections for PDA-5003]

B

R

VD

HD (H/V SYNC)

G(ON SYNC)

ANALOG RGB

INPUT5

When using INPUT5, set the impedance selector switch
to match the output impedance of the connected
computer’s synchronization signal.
When the output impedance of the sync signal is below
75

Ω remove the video card and set the impedance

selector switch to 75

Ω (page 6).

On-screen setup is necessary after connection.
Please see pages 18 to 20.

Notes

÷ When making composite SYNC connections, do not connect

anything to the VD jack. If connected to, the picture may not
be displayed properly.

÷ Some types of computer devices manufactured by Apple

Computer, Inc. are equipped with both G ON SYNC and
composite SYNC outputs. This type of component should be
connected using the G ON SYNC connection (page 11).

Advertising
Ce manuel est liée aux produits suivants: