Pioneer PDA-5003 - Manuel (Page 27)

24
En
English
Operation
1
Press the remote control unit’s POINT ZOOM
button.
66.0
22.1
R12 24
10
ZOOM P.ZOOM SCROLL
x 1.5
Zoom-Navi subscreen
Each time the POINT ZOOM button is pressed, the
zoom ratio alternates in the following order:
Note
During use of the POINT ZOOM function, the screen size cannot
be changed.
Operation
Enlarging one part of the screen
(POINT ZOOM)
This plasma display allows enlarging of the screen image
by ratios of [x 1.5], [x 2], and [x 3]. When enlarging the
screen, the
5/∞/2/3 buttons can be used to move the
enlarged viewing area around the screen.
¶ The range of zoom possible can be confirmed by viewing
the Zoom-Navi subscreen at the upper right of the main
screen. The Zoom-Navi subscreen is displayed for about
three seconds whenever the POINT ZOOM button, one
of the
5/∞/2/3 buttons, or DISPLAY button is pressed.
POINT
ZOOM
DISPLAY
5/∞/2/3
2 Using the 5/∞/2/3 buttons, move the screen to
the desired part of the image.
10 84.3
50 10
22.1
R12 24
SCROLL
x 1.5
ZOOM P.ZOOM
÷ Pressing the POINT ZOOM and 5/∞/2/3 buttons
again will change the zoom ratio and the position of
screen enlarged.
÷ If the input signal changes, or if the menu screen is
displayed and the input is changed, or if the
multiscreen mode is selected, the POINT ZOOM
function will be canceled.
Note
Be aware that when the display is used for commercial or public
viewing purposes, selecting the [WIDE], [ZOOM], [CINEMA] or
[FULL] mode settings may violate the rights of authors protected
under copyright law.
3 OFF 3 x 1.5 3 x 2 3 x 3