Lifescan SPD2410BD - Manuel (Page 71)

SETTINGS
62
United States. If you are not sure which unit of
measurement to use, please check with your
Health Care Professional. The mmol/L results
include a decimal point and the mg/dL results
do not.
To change the unit of measurement to
mg/dL, press the green
C button.
This symbol will flash on the display.
Press the blue power button to move to the
beep signals setting.
Beep Signals
The OneTouch ® SureStep ® Meter uses beep-
ing tones to signal certain steps in the proce-
dure. However, these “beep” signals do not
mean that the step was performed correctly.
Three types of beep signals sound.
1. A single, short beep identifies each step
in the test procedure.
2. A single, long beep accompanies error
messages, a “HI” result, and certain mis-
takes in doing the test procedure.
3. A three–tone beep sounds when the
meter displays a test result and when the
meter moves to the beep signal feature
in set–up mode.
DCO_05090602A_OTSS_OB_CA_ENG 12/3/03 1:27 PM Page 62