JVC D-ILA DLA-QX1G - Manuel (Page 56)

54
Corrective action
• Check the exhaust vents and
remove any blocking objects.
• The lamp life may be near its
end. Consult your dealer.
• Check that the side panel of the
is fixed firmly. Consult your dealer.
• Open the internal shutter by
pressing the remote control unit’s
SHUTTER OFF button.
• Consult you dealer to replace the
light-source lamp.
• Check the exhaust vents and
intake area, and remove any
blocking objects.
Turn off the MAIN POWER switch
and wait until the projector cools
down, and turn on the MAIN
POWER switch again.
If the error code is still indicated,
consult your dealer.
• Check the room temperature and
ventilate the room.
• There may be something wrong
in the light-source lamp unit.
Turn off the MAIN POWER switch
and unplug the power cord, then
consult your dealer.
• Turn off the MAIN POWER switch
and unplug the power cord, then
consult your dealer.
Cause
• The temperature of the light-source
lamp is abnormally high.
• The light-source lamp cannot be turned
on.
• The side panel of the projector is
broken away.
• The internal shutter is activated.
• The lamp life may be near its end.
(“80” for 900 hours, “81” for 1000
hours)
• The internal temperature of the
projector is abnormally high.
• The room temperature is too high to
operate the projector correctly.
• The lamp is turned off while projecting.
• An internal error has occurred.
Error code
The following shows the error code indicated on the status code display. When an error code is indicated, take the corrective
action described here.
to
Warning Messages (Cont.)
EN51-54QX1G_f.pm6 02.3.7, 13:38 54