JVC D-ILA DLA-QX1G - Manuel (Page 15)

13
ENGLISH
Connector Panel (Cont.)
How to install the optional VICs
1 Remove the slot panel from the slot of the
projector.
1) Remove two screws on the slot panel, one on each end,
from an empty slot.
2) Take off the slot panel.
2 Install the VIC.
1) Aligning both ends of the PC board of the VIC with the
grooves inside the slot, insert the VIC into the slot.
2) Push the VIC fully so that two connectors on inner surface
of the VIC are securely plugged into the sockets inside the
slot.
3 Fasten the VIC to the projector.
After inserting the VIC into the slot, fasten it to the projector
with two screws attached to the VIC.
About the optional VICs
HDTV Analog VIC
Å LED
This LED lights up when the HDTV Analog VIC is
selected.
ı Y, P b , P r input terminal (BNC x 3)
These are Y, Pb, Pr input terminals for HD signal
(SMPTE260M/274M/296M).
HD-SDI VIC
Å LED
This LED lights up when the HD-SDI VIC is se-
lected.
ı SDI input/output (through) terminal (BNC x 2)
These are input and output terminals for HD-SDI
signal (SMPTE292M).
HD-SDI VIC
IN OUT
Å ı
HDTV Analog VIC
Y P b P r
ı
Å
REMOTE CO NT RO L
RS-232C OUT
RS -232C IN
R
G
B Y
H/C S
RGB Analog
VIC
RE MO TE
CONTROL
RS -232 C O UT
RS-232C
IN
R
G
B Y
H/C S
RGB Analog
VIC
R
G
B
Y
H/C S
RGB Analog
VIC
HD TV Analog VIC Y
P b
P r
REMOTE CONTROL
RS-232C OUT
RS-232C IN
R
G
B
Y
H/C S
RGB Analog
VIC
HDTV Analog
VIC
Y
P b
P r
Notes
• To avoid penetrating of the dust, do not remove the slot
panel from the unused VIC slot.
• When replacing the slot panel, set it with the arrow up
(indicated on the both ends of the slot panel) as shown:
arrow
EN07-16QX1G_f.pm6 02.3.7, 13:37 13