JVC D-ILA DLA-QX1G - Manuel (Page 26)

24
Installing the Projector (Cont.)
Effective Range and Distance of the Remote Control Unit
The remote control unit can be used as either a wireless remote control unit or a wired one.
■ Using as a wireless remote control unit
Aim the remote control unit as the remote sensor on the front or control panel of the projector.
The operable distance of the remote control unit is about 32.8 ft (10 m) for direct reception. The remote control unit can be used
by having its signal reflected on the screen. In this case, the total distance of “A + B” should be about 32.8 ft (10 m) or less. The
operable angles of the remote control unit are 50° horizontally, 15° vertically.
■ Using as a wired remote control unit
Connect the supplied remote control cable between the remote control unit and the REMOTE terminal on the connector panel
of the projector.
Using it as a wired remote control unit, you do not have to worry about the operable angle of the unit, though the operable
distance is limited by the length of the remote cable (approx. 49.2 ft (15 m)).
ZOOM
KEYST ONE SHUTTER
DIGIT AL ZOOM
SH IFT FOC US
OPERA
TE
EXIT
ME NU
MODE BA CK LIGHT
ENTER
VIC 1 VIC 2 VIC 3
T
W
T
W ON
OFF
LOCK
UNLOCK
RM-MQX1G REMO
TE CONTR
OL UNIT ZO OM FO CU S T
W ME NU
EN TER EXI T
VIC SE LEC T 1 2 3 KE Y S TO NE OP ER ATE MO DE STA ND BY
REMOTE
CONTROL
RS-232C OUT RS-232C IN
A
15°
50°
B
Note
• When the remote control unit is used as a wired unit, its signal transmitter and projector’s remote sensor do not work.
CAUTION
• Do not extend the remote cable. Doing so could cause a malfunction of the projector.
EN17-31QX1G_f.pm6 02.3.7, 13:37 24