JVC D-ILA DLA-QX1G - Manuel (Page 33)

31
ENGLISH
Connecting to Various Devices (Cont.)
After all devices have finished being connected, connect the projector’s power cord. At this time, do not turn on the MAIN
POWER switch yet.
• Do not turn on the projector without installing the lens unit (not supplied). Doing so will cause the lens-hole blind cover (black
one) initially installed to be deformed by heat from the light-source lamp.
CAUTIONS
To prevent fire and electric shock, observe the following:
• When you do not use the devices, pull out their power cords from
wall outlets.
• Do not connect the devices with power cords other than supplied.
• Do not use voltage other than the power voltage indicated.
• Do not scar, damage, or work on the power cords. Also, do not put a
heavy object on, heat or pull the power cords, otherwise they may
be damaged.
• Do not insert or pull out the plugs with a wet hand.
Connecting the Power Cord (Supplied)
CAUTIONS
• Since the power requirement of the projector is high, be sure to
insert the power plug directly into a wall outlet.
• This projector requires a single phase, 3-wire, 200V to 240V wall
outlet.
■ To use the projector
• Remove the lens cap before using the pro-
jector.
1. Remove the power input terminal cover.
The cover is a screwed type. Turn the cover in the
direction of the arrow to remove.
2 Insert the plug of the supplied
power cord into a wall outlet.
3 (For U.S.A. only)
Turn the plug to the right to fix.
1 Insert the supplied power cord
into the power input terminal (AC
IN
) of the projector.
2. Insert the plug of the supplied power cord into
the power input terminal of the projector.
Align the groove on the projector plug of the power
cord with the claw on the power input terminal of the
projector, and push the plug in firmly.
After that, turn the ring on the plug in the direction of
the arrow to fix.
CAUTIONS
• Be sure to remove the cap; otherwise, it may be deformed (or
degraded in quality) or melted, possibly causing a fire or
malfunction.
• Do not operate the projector with the lens cap attached. Doing
so can deform the lens cap because of the heat. A metallic
lens cap can get hot and cause injury.
ZO OM FO CUS T
W
ME NU
EN TER EXIT
VIC SE LECT 1 2 3 KE Y S TO NE OPE RA TE MO DE STA ND BY
RE MOT E CO NT RO L RS -232 C O UT RS -23 2C IN
R G B V H/C S
RG B A na log VIC
To wall AC outlet
Power cord (supplied)
1
2
200 V to 240 V, single
phase
Lens cap
■ Preparation for United Kingdom only
Attach a plug which matches your wall outlet to the power
code. For details, consult your dealer.
EN17-31QX1G_f.pm6 02.3.7, 13:37 31