Thermor Riva 2 - Manuel (Page 19)

17
M
AINTENANCE
- To maintain the performance of the device, about twice per year, clear the dust.
Do not use abrasive products.
- For models with a fan, use a vacuum cleaner to clear the air inlet and outlet grids, as well as the fil-
ter (refer to the Filter paragraph).
- When ventilating the room, stop the heating by setting the switch to the Arrêt position.
- If you leave for several hours, lower the temperature.
Leaving for: Less than 24 hours :do not touch the controls.
More than 24 hours or during summer :set the temperature knob to .
R
ECOMMENDATIONS OF USE
W
ARNING
- When filling a Mixed device, the hot water circuit must necessarily be used to allow the fluid to
expand in the heating circuit.
- This device is not intended for use by persons (including children) with physical, sensory or mental
disability, or by persons lacking experience or knowledge, unless they have received from a person
in charge of their safety adequate supervision or preliminary instructions on how to use the device.
- Prevent children from climbing on the device.
- In order to avoid a hazard for very young children, this device should be installed so that the lowest
heated rail is at least 600 mm above the floor.
- For safety reasons, it is strictly forbidden to top up unmixed devices. If necessary, contact the manu-
facturer’s After-Sales Service or a qualified technician.
- Any intervention on the electrical parts must be performed by skilled staff.
- Do not insert objects or paper in the device.
- Upon first warming, a slight smell may appear, due to the evacuation of compounds used during the
device’s manufacturing.
- The casing may be hot, even when the device is off.
GB