Sony MDS-JB930 - Manuel (Page 21)

When INPUT is set to 0PT1, 0PT2 or COAX
The digital signal input from the DIGITAL IN
connector is output to the DIGITAL OUT connector
after passing through the sampling rate converter, and
then to the LINE (ANALOG) OUT jacks and PHONES
jack after D/A conversion. DA" appears in the
display during this time.
Erasing blank portions automatically
(Smart Space/Auto Cut)
The deck can be set to automatically erase any blanks that
are produced when the signal is interrupted during
recording. The function which activates (Smart Space or
Auto Cut) depends on the length of the interruption, as
described below.
Smart Space
If the signal is interrupted for less than 30 seconds. Smart
Space replaces the blank portion with a blank space of
about three seconds, then continues the recording. "Smart
Space" appears in the display during this time.
3 Turn AMS (or press /►►! repeatedly) to select
the setting, then press AMS or YES.
To Select
Turn on Smart Space and Auto Cut S.Space On (factory
setting)
Turn off Smart Space and Auto Cut S.Space Off
4 Press MENU/NO.
Notes
• If you start recording with no signal input, Smart Space and
Auto Cut will not operate regardless of the setting.
• Smart Space does not affect the order of the track numbers
being recorded, ev'en if the blank space occurs in the middle of
a track.
• Auto Cut is automatically turned on or off in tandem with
Smart Space.
• If you turn off the deck or disconnect the AC power cord, the
deck will store the last setting ("S.Space On" or "S.Space Off")
and recall it the next time you turn on the deck.
• If the deck continues recording pause for about ten minutes
after the Auto Cut activated, recording stops automatically.
n
m rt
o
3
Ifi
0
3
S
o
wi
Auto Cut
If the signal is interrupted for about 30 seconds , Auto Cut
replaces the blank portion with a blank space of about
three seconds, then pauses the recording. "Auto Cut"
appears in the display during this time.
Do the procedure below to turn Smart Space and Auto
Cut on or off.
1 While the deck is stopped, press MENU/NO twice.
"Setup Menu" appears in the display.
2 Turn AMS (or press l◄◄/►►l repeatedly) until
"S.Space On" appears, then press AMS or YES.
2 V