Breville BES800XL - Manuel (Page 26)

25
CARE & CLEANING
CLEANING THE STEAM WANd ANd
fROTHING ATTACHMENT
• The Steam Wand and Frothing
Attachment should always be cleaned
after frothing milk.
• Remove the Frothing Attachment and
rinse in warm tap water. Ensure the two
fine steam holes on either end of the
Frothing Attachment are clear. Use the
pin on the Cleaning Tool to unblock
these holes.
• Wipe the Steam Wand with a damp
cloth, then with the Steam Wand
directed back into the drip tray, briefly
set the Selector Control to the ‘Steam’
position and press the Hot Water button.
This will clear any remaining milk from
inside the Steam Wand.
• Ensure the Selector Control is in the
‘Standby’ position. Press the ‘ON/OFF’
button to ‘OFF’, unplug the power cord
and allow the machine to cool.
• If the Steam Wand remains blocked, use
the pin on the Cleaning Tool to clear
the opening.
• If the Steam Wand continues to be
blocked, the tip of the Steam Wand can
be removed by using the spanner in the
middle of the Cleaning Tool.
• Soak the tip in hot water before
using the pin on the Cleaning Tool
to unblock. Replace the tip back onto
the Steam Wand and secure with the
Cleaning Tool.