Breville BES800XL - Manuel (Page 21)

20
OPERATING yOUR BREvILLE dUO-TEMP™ ESPRESSO MACHINE
STEAM BUTTON/HOT
WATER BUTTON
• The Steam button surround will
automatically illuminate when the
machine is switched ‘On’ with the Power
On/Off button.
• The machine will always automatically
default to the Steam button when the
appliance is first switched on.
• Both buttons cannot be operated at the
same time.
• To select steam: when the Steam button
surround is illuminated, just set the
Selector Control to ‘Steam’
• To select hot water: press the Hot Water
button and the surround will illuminate,
then just set the Selector Control to
‘Steam’.
• If the machine remains switched ‘On’,
the last button function used (Steam or
Hot Water) will stay illuminated.
NOTE
Always ensure that the Frothing
Attachment has been firmly pushed
onto the Steam Wand and connects with
the rubber surround.
For best results use cold fresh milk (low
fat milk will froth easier).
Always clean the Steam Wand and
Frothing Attachment after every use.
Refer to ‘Care and Cleaning’ on page 25.
AUTO PURGE fUNCTION
For brewing more coffee immediately after
using the steam function, the BES800XL
features an auto-purge function. This
ensures that ground coffee will not be
burnt by the initial water flow from the
thermoblock that could be too hot.
Instead this water is automatically released
internally into the Drip Tray ensuring
that the internal thermostat is at optimal
temperature for extracting coffee. Your
coffee will always be extracted at this
optimal temperature ensuring only the best
flavored coffee is achieved.
WARNING
Do not allow milk to run over the top of
the frothing attachment, otherwise it
will not function properly.
To avoid splattering of hot milk, do
not lift the end of the frothing
attachment above the surface of the
milk while frothing.
Ensure the selector control is in the
‘standby’ position before removing the
frothing jug.