Napoleon Fireplaces Dream - BGD90 - Manuel (Page 36)

36
W415-0826 / B / 07.11.11
Follow the door removal instructions. Remove the right side brick panel. Remove the four screws from the in-
ner access panel.
NOTE: A new gasket will be required, when re-installing the access panel, see “REPLACEMENTS” sec-
tion.
The control area can be accessed either through the control door or through the access panel inside the fi re-
box. The bulkhead fi ttings that are part of the gas supply to the burners can be accessed through the bulkhead
access plate.
A. Open the right control door by pulling bottom portion away from
magnet catch.
B. Remove the hearth strip by lifting up and away from appliance.
C. Remove the receiver by pulling the left side of the plate away from the
bracket.
D. Once disengaged pull the wiring harness out from the back of receiver.
8.0 REMOTE AND VALVE ACCESS
8.1 INNER ACCESS PANEL
Follow the door removal instructions. Remove the
right side brick panel and hearth pad. Remove the
four screws from the bulkhead access panel.
NOTE: A new gasket will be required, when re-
installing the bulkhead access panel, see “RE-
PLACEMENTS” section.
8.2 BULKHEAD ACCESS PLATE
8.3 REMOTE RECEIVER REMOVAL
BULKHEAD
ACCESS
PANEL
GASKET