Sony TA-VA80ES - Manuel (Page 17)

17 EN
Getting Started Dolby Surround Setup
Adjusting the speaker volume Z
Use the remote while seated in your listening position
to adjust the volume of each speaker.
Note
This amplifier incorporates a new test tone with a frequency
centered at 800 Hz for easier speaker volume adjustment.
TEST TONE
REAR
LEVEL +/–
CENTER
LEVEL +/–
SOUND FIELD
ON/OFF
GENRE MODE
DIGITAL
PROCESSING
CONTROL
SLOPE BAND
EQ/
TONE
DIGTAL PROCESSING CONTROL
PROGRAMMABLE
— LEVEL —
DIRECT REAR
BASS
BOOST
MUTING
CENTER
MASTER VOL
MODE GENRE
— SOUND FIELD —
ON/OFF
TEST
TONE
+ +
– –
POSITION – SUB CH +
— RMS —
SWAP
ANT
TV/VTR
= ) 0 + D. SKIP
CLEAR DIRECTION P IN P JUMP
p (
DPC MODE
9 P r
1
Press SOUND FIELD ON/OFF to turn on the
sound field.
2 Press GENRE repeatedly to select “DOLBY.”
3
Press MODE to select “NORMAL SURROUND”
or “ENHANCED SURROUND.”
4
Press TEST TONE.
You will hear the test tone from each speaker in
sequence.
5
From your listening position, use the digital
processing control buttons (
/ ) to select the
parameter to be set and use the buttons ( / )
to select the setting so that the test tone can be
heard at the same level from all speakers.
To adjust Select And set between
rear speaker
balance REAR L R L (left) and R (right)
rear speaker
level REAR –20.0dB and +10.0dB
(in 0.5 dB steps)
center speaker
level CENTER –20.0dB and +10.0dB
(in 0.5 dB steps)
subwoofer
level SUB WOOFER –20.0dB and +10.0dB
(in 0.5 dB steps)
During adjustment of the respective speaker level/
balance, the test tone is output from the speaker(s)
only.
After adjusting the subwoofer level, the test tone
turns off automatically.
To turn off the test tone
Press TEST TONE.
z
You can use other buttons to adjust the center and
rear speaker level
Press CENTER LEVEL +/– or REAR LEVEL +/– in Step
5 above.
Note
Be sure to select “NORMAL SURROUND” or “ENHANCED
SURROUND” before outputting the test tone.