Sony DSR-40/40P - Manuel (Page 45)

Chapter 3 Using the Unit as a Player in an Editing System
Chapter 3 Using the Unit as a Player in an Editing System
45 GB
Performing a phase adjustment operation
1
Press the SCH button on the vectorscope.
The vectorscope switches to “SCH” mode.
2
Press the B channel button on the vectorscope.
This displays the black burst signal from the switcher.
3
Press the EXT button on the vectorscope.
This switches the vectorscope to external synchronization mode.
4
Adjust the phase synchronization control on the vectorscope so that the
sync and subcarrier phases are close to the reference line.
Subcarrier phase
Sync phase
Align the sync and subcarrier phase of the black burst signal
to the reference line.
Reference line
5
Output the player 1 signal from the switcher, using the PVE-500.
6
Press the A channel button on the vectorscope.
This displays the sync phase and subcarrier phase (composite signals
only) of the signal from player 1.
7
On player 1, adjust the SYNC control, using the H PHASE COARSE
menu for rough adjustment and the H PHASE FINE menu for fine
adjustment, so that the output from player 1 on channel (A) is in
correct phase alignment with the black burst signal on channel (B) (See
page 53).
(Continued)