Sony DSR-40/40P - Manuel (Page 44)

Chapter 3 Using the Unit as a Player in an Editing System
44 GB
Chapter 3 Using the Unit as a Player in an Editing System
Adjusting the Sync and Subcarrier Phases
When using two or more players, as in an A/B roll editing system, phase
synchronization of the signals (i.e. system sync) is necessary and for
composite signals only, the subcarrier phase must also be in sync. If not,
picture instabilities or color break-up may occur at edit points.
After configuring the editing system, use a vectorscope to adjust the sync
and subcarrier phase of the recorder and players. Subcarrier phase
adjustment is necessary when using composite signals or Y/C signals.
DSR-40/40P (player 1)
Switcher
BLACK
BURST
OUT
PGM OUT
75
Ω
coaxial cable (B)
75
Ω
coaxial cable (A)
A IN
B IN
REF. VIDEO
EXT IN
Note
Note
Ensure that the 75 Ω coaxial cables (A)
and (B) are of the same length.
PVE-500 Editing control unit
DUP
INPUT SELECT TC
TAPE REMAIN
COUNTER
COUNTER SELECT
CH-1/2
CH-3/4 MIX
AUDIO MONITOR
REPEAT
REC OFF
TIMER REMOTE
LOCAL
MENU
SET
DSR-85/85P (recorder)
Vectorscope (Tektronix
1750/1751, etc.)
UVW-1600/1600P (player 2)
Note
The sync and subcarrier phase of the output signal from the DFS-500/
DFS-500P Switcher are automatically adjusted.