Denon ADV-700 - Manuel (Page 36)

36
4 Start playback on the selected component.
• For operating instructions, refer to the component’s
manual.
• The volume can be adjusted within the range of –60 to 0 to
18 dB. However, when the channel level is set as
described, if the volume for any channel is set at +1 dB or
greater, the volume cannot be adjusted up to 18 dB. (In this
case the maximum volume adjustment range is “18 dB —
(Maximum value of channel level)”.)
5 Either turn the MASTER VOLUME dial on the main unit or
use the VOLUME buttons on the remote control unit to
adjust the volume.
M.VOLUME -20
MASTER VOLUME
Main unit
VOLUME
Remote control unit
The volume level is displayed
on the display.
NOTE:
• The digital input indicator will light when “DIG” playing CD-
ROMs containing data other than audio signals, but no sound
will be heard.
Input mode when playing DTS sources
• Noise will be output if DTS-compatible CDs or LDs are played in
the “ANALOG” or “PCM” mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to “DTS”.
• Noise may be generated at the beginning of playback and while
searching during DTS playback in the AUTO mode. If so, play in
the DTS mode.
• The “DIG” lights when digital signals are being input properly. If the
LED does not light, check whether the digital input component
setup and connections are correct and whether the component’s
power is turned on.
PRO LOGIC II
DIG PCM
DIGITAL
DTS
DIG PCM
DIGITAL
DTS
DIG PCM
DIGITAL
DTS
AUTO
ANA
DIG PCM DTS
ANA
DIG PCM AUTO DTS
ANA
DIG PCM AUTO DTS
ANA
DIG PCM AUTO DTS
Input mode display
• In the AUTO mode
• In the DIGITAL PCM mode
• In the DIGITAL DTS mode
• In the ANALOG mode
One of these lights, depending on
the input signal.
Lit
One of these
lights,
depending on
the input signal.
Input signal display
• DOLBY DIGITAL
• DTS
• PCM
STATUS
Main unit
FUNCTION
/SELECT
Main unit
STATUS
Remote control unit
2 Cheking the currently playing program source, etc.
Either press the STATUS button on the main unit then turn
the FUNCTION / SELECT dial or press the STATUS button
on the remote control unit to check the unit’s operating
status.
ENGLISH