Panasonic WV-BPR554 - Manuel (Page 31)

When ON is selected for SUPER-D, the SENS UP
SELECT function for the WV-CU254 or WV-CU300
system controller does not work.
Use the buttons on the side of the camera for
setup.
While the SENS UP function is selected, noise or
spots may appear in the picture when the sensitivi­
ty of the camera is increased. This is a normal
phenomenon.
6. Synchronization Setting (SYNC)
You can select internal sync mode (INT) or line-lock
mode (LL). Additionally, this model accepts VS signal
(B/W composite video or composite sync signal). The
VD2 signal (multiplexed vertical drive signal) with the
composite video output signal from external equipment
such as a Matrix Switcher is also acceptable.
Whenever the VD2 signal is supplied to this camera,
the camera automatically switches to the VD2 sync
mode.
1. Move the cursor to the SYNC parameter and
seleot line-lock (LL) or interna! (INT).
2. Press E3 ■ If LL is selected, the SYNC menu
appears. (If INT is selected, the synchronization
mode is automatically set to internal sync pulse,
and the menu is not displayed.)
— —\
•* CAM SET UP * *
CAMERA ID OFF
"X
A1X:/ELC ALC
"X
SHUTTER —
AGC ON
SENS UP OFF
SYNC INT
MOTION DET OFF
LENS DRIVE DC
RET
L /
Important Notices:
1. The priority for the sync modes is as follows.
1. Multiplexed Vertical Drive (VD2) (Highest pri­
ority)
2. Line-lock (LL)
3. B/W Composite Video or Composite Sync
Signal (VS)
4. Internal Sync (INT) (Lowest priority)
2. When the interna! sync mode is to be used, select
INT. No gen-lock input signal should be supplied
to the Gen-lock Input Connector on the rear panel.
3. Whenever the multiplexed vertical drive pulse
(VD2) is supplied to the camera from an external
equipment such as a Matrix Switcher, the camera
sync mode is automatically switched to the VD2
mode.
4. When the VS gen-lock mode is to be used select
INT from this menu and supply the gen-lock input
signal to the Gen-lock Input Connector on the rear
panel.
-29-