Panasonic WV-BPR554 - Manuel (Page 21)

* Opening the Setup Menu
Press and hold down O for a second or longer.
The SET UP menu appears on the monitor as shown
above.
* Editing the CAM SET UP and RS485 Menu
Important Notice:
When the words SET UP DISABLE appear on the
bottom line of the SET UP menu, you cannot
change the currently active settings. This is to pre*
vent accidental changing of the settings.
To edit the SET UP menu (change settings), use
and E&Í or €] and to move the cursor to SET
UP DISABLE in the bottom line.
Press EJ. SET UP DISABLE changes to SET UP
ENABLE. Move the cursor to END, then to the item(s)
you want to change.
Move the cursor to CAMERA or RS485, then press El
to display the desired setting menu.
Check the current settings on the menu.
** CAM BET DP ••
CAMERA ID OFF “1
ALC/ELC ALC
SHUTTER —
AOC OH
SENS DP OFF
SYNC INT
MOTION DET OFF
LENS DRIVE DC
^RET
J
** RS4B5 SET DP
UNIT NUMBER 1
BAUD RATE 19200
DATA BIT e
PARITY CHECK NONE
STOP BIT 1
XON/XOFF NOT USE
WAIT TIME OFF
ALARM DATA POLLING
DELAY TIME OFF
^ RET
-19-