Installation of auto iris lens connector – Panasonic WV-BPR554 Manuel d'utilisation

Page 14

Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

Advertising
background image

Installation of Auto Iris Lens Connector

Install the lens connector (YFE4191J100) when using a

video drive ALC tens.

The installation should be made by qualified ser­

vice personnel or system installers.

(1) Cut the iris control cable at the edge of the lens

connector to remove the existing lens connector
and then remove the outer cable cover as shown
in the diagram below.

The pin assignment of the lens connector is as fol­

lows:

Pin 1; Power source; +9 V DC, 50 mA Max,

Pin 2

Pin 3

Pin 4

Not used

Video signal; 1,3 V[p-p]/40 kQ

Shield, ground

Pin 4

(2) After connection, assemble the lens connector as

follows.

Note:

When the iris control cable is too thick to

lock the connector cover with the connector
base, cut off the rib on the connector,

{Select VIDEO for LENS DRIVE of the CAM

SET UP menu.)

-12-

Advertising
Ce manuel est liée aux produits suivants: