Panasonic WV-BPR554 - Manuel (Page 23)

SEHING PROCEDURES
i:—‘--- * . * .
4.
*
• RS485 Setup
You can remote control this camera by using a speci­
fied extension unit such as computer with a modem.
The RS485 menu is used to set the parameters of the
items for RS485 site communication below.
Move the cursor to RS485 of the SET UP menu and
press EU ■ The RS485 menu appears on the monitor
screen.
** RS435 SET UP **
UNIT NUMBER 1
BAUD RATE 19200
DATA BIT 8
PARITY CHECK NONE
STOP BIT 1
XOU/XOFP HOT USE
WAIT TIME OPP
AIiARH DATA POLLING
DELAY TIME OPP
RET
UNIT NUMBER
This item is used to select the camera number that is
used with RS485 communication.
1. Move the cursor to the parameter of UNIT NUM­
BER.
2. Select the camera number to be used with RS485
communication and press El -
BAUD RATE
This item is used to select the transmission speed for
the RS485 communication. {BAUD is the unit of bit per
second.)
1. Move the cursor to the parameter of BAUD RATE.
2. Select the transmission speed and press E],
DATA BIT
This item is used to select the data bits for the RS485
communication.
1. Move the cursor to the DATA BIT parameter.
2. Select the data bits and press El.
PARITY CHECK
This item is used to select the parity for the RS485
communication.
1. Move the cursor to the PARITY CHECK parameter,
2. Select the parity and press El.
STOP BIT
This item is used to select the stop bit for the RS485
communication.
1. Move the cursor to the STOP BIT parameter.
2. Select the stop bits and press El ■
-21-