Panasonic WV-BPR554 - Manuel (Page 24)

X ON/X OFF
This item is used to select applying the flow control or
not.
1. Move the cursor to the X ON/X OFF parameter.
2. Select NOT USE (not apply flow control) or USE
(apply flow control) and press E],
WAIT TIME
This item is used to select the wait time to re-transmit
after confirming that no data is received from the con­
troller.
1. Move the cursor to the WAIT TIME parameter.
2. Select the wait time and press ■
When no transmission is needed, select OFF.
ALARM DATA
This item is used to select the way of transmitting the
alarm data.
1. Move the cursor to the ALARM DATA parameter.
2. Select the alarm data transmission mode from fol­
lowing parameters:
POLLING;
Transmit the alarm data to the controller to
request from the controller.
AUT01:
Transmit the alarm data each time the alarm
signal is received.
AUTO 2:
Transmit the alarm data five seconds each.
DELAY TIME
This item is used to select the time to transmit the
acknowledge request when communicating on a two-
line connection.
1. Move the cursor to the DELAY TIME parameter.
2. Select the delay time.
Note:
This item appears only when a two-line con­
nection is used.
• Installation of Software for RS485
Communication
1. Insert the Install Disk 1 to the C drive of your PC.
2. Input command as follows,
C:\SETUP El
The installation starts.
3. When the window that says “Please insert the disk
labeled: “Disk 2" into drive C:" appears on the
monitor screen, insert the Install Disk 2 and press
4. When the installation is completed, the window
that says “485_GUI Setup was completed suc­
cessfully," appears on the monitor screen.
5. After installation of 485_GUI Setup is completed,
open 485_GUI Setup, and set the RS465 commu­
nication parameters.
-22-