Tweco 7-5207 - Manuel (Page 2)

February 28, 2003 / 28 Février, 2003 2 Manual/Manuel 0-2883
8. Connect the ATC Adapter lead connections to the Torch
Adapter Kit parts installed onto the Power Supply as de-
scribed in the instructions supplied with the Torch Adapter
Kit.
9. Tighten the Strain Relief onto the ATC Adapter Leads.
10. Connect the RPT Torch ATC connector to the ATC Adapter
connection. The connectors should push together with a
very small amount of pressure. Secure the connection by
turning the locking nut clockwise until it stops. DO NOT
use the locking nut to pull the connection together.
11. Reinstall any covers removed, see WARNING.
12. Install the proper torch consumables for the Power Supply
amperage
13. Reconnect input power to the Power Supply and turn ON
the unit.
14. Set proper gas pressure or flow.
15. Test torch for proper operation.
WARNING
Make sure that the Control Connector Plug
wires DO NOT contact the Adapter Fitting af-
ter all leads are connected.
Connector and Receptacle Pin Layout
NOTE
Every effort has been made to provide complete and accurate information in this manual. However, the
publisher does not assume and hereby disclaims any liability to any party for any loss or damage caused
by errors or omissions in this manual, whether such errors result from negligence, accident or any other
cause.
Female ATC
Front
1
2
3
4
5
6
7
8
5
6
7
8
1
2
3
4
1 - Black
2 - Orange
PIP
Switch
A-03614
3 - White
4 - Green
Male ATC
Front