Tweco 7-3434 - Manuel

Date: September/Septembre 6, 2002 1 Manual/Manuel 0-2757
General Information
This Replacement Torch Adapter Kit is to be used to connect the Thermal Dynamics Plasma RPT Series Cutting Torch
to the following equipment:
• ESAB SIDEWINDER 50, SIDEWINDER 55 and SIDEWINDER 105
• Thermal Dynamics PAK 8XR, 10XR, 1000XR, and 1250XR
• Thermal Dynamics PakMaster 50, internal connection, and PakMaster 100
Parts Supplied
The following parts are included in this kit:
• Control Connector Plug with Connectors - 1 ea
• Secondary Gas Output Plug - 1 ea
• Strain Relief - 1 ea
Installation
Install the Adapter Kit per the following procedure:
1. Turn OFF the power supply.
2. Disconnect the main input power to the power supply.
3. Remove the existing torch from the power supply, removing covers as required.
4. The Strain Relief included in this kit is a device to prevent damage to the Torch Leads resulting from a direct
through panel exposure. All plasma cutting systems may not be equipped to utilize this Strain Relief.
On units where the Strain Relief can be used, install as follows:
a. Remove the retaining nut from the Strain Relief.
b. Place the end of the Strain Relief into the hole in the unit.
c. Secure the Strain Relief to the Power Supply with the retaining nut.
d. Loosen the leads capture nut on the outside of the Strain Relief.
e. Feed the torch lead ends through the Strain Relief and into the unit.
f. Tighten the leads capture nut to secure the Strain Relief onto the Torch Leads.
Manual 0-2757
RPT Adapter Kit
Catalog # 7-3434
Installation Instructions
© 1998 Thermal Dynamics Corp., Printed in USA
82 Benning Street, West Lebanon, NH 03784 USA
(603) 298-5711 • www.thermal-dynamics.com