Tweco 7-3430 - Manuel

January 16, 2004 / 16 Janvier, 2004 1 Manual/Manuel 0-2763
Manual 0-2763
RPT Adapter Kit
Catalog # 7-3430
Installation Instructions
General Information
This Replacement Torch Adapter Kit is to be used to connect the Thermal Dynamics Plasma RPT Series Cutting Torch
to the following equipment:
• HYPERTHERM MAX 40 HF Start, MAX 70, MAX 80 and MAX 100
• L-TEC PCS-40
• MILLER SPECTRUM 700, 1000, 1250, PLUS
• POWCON STARCUT
Parts Supplied
The following parts are included in this kit:
• Control Connector Wire with Connectors & Spade Lugs - 1 ea
• Control Connector Wire with Connectors & Fastons - 2 ea
• Adapter Fitting - 1 ea
• Pilot Adapter Fitting - 1 ea
• Insulating Sleeve - 1 ea
• In-Line Splice - 1 ea
• Protective Boot - 1 ea
• Restrictor Pin Kit No. 8-3440
© 1998 Thermal Dynamics Corp., Printed in USA
82 Benning Street, West Lebanon, NH 03784 USA
(603) 298-5711 • www.thermal-dynamics.com
NOTE
This kit includes parts that are not used in all applications. Read these directions carefully to determine whether all
parts are needed.
Installation on Power Supplies Without Quick Disconnect
Install the Adapter Kit as follows:
1. Turn OFF the power supply.
2. Disconnect the main input power to the power supply.
3. Remove the existing torch from the power supply, removing covers as required.
4. Slide the Protective Boot, included in this kit, over the end of the Negative / Plasma Lead.
5. Place the Adapter Fitting provided into the Power Supply torch power cable fitting (-) and tighten securely.
6. Install the Pilot Adapter Fitting onto the Power Supply pilot connection.
7. Connect the pilot wire (+) from the replacement torch to the Power Supply Pilot Adapter Fitting. Secure the wire
with the bolt and washers provided.