Tweco 7-3457 - Manuel (Page 3)

Manual / Manuel 0-2891 3 June 16, 2003 / 16 Juin, 2003
Installation and Use
1. Use the connecting ring on the ATC Adapter Kit to secure the male connector in place in the receptacle. Do not use
tools. If resistance is felt, unthread the connecting ring, check the alignment of the connector and receptacle, and
reassemble.
2. Install the proper torch consumables for the Power Supply amperage in the Torch. Follow instructions in the
Torch Instruction Manual.
3. Connect the torch to the Power Supply.
Connecting Ring
A-03423
To Power Supply Receptacle
RPT Adapter
ATC Adapter Kit
Torch Lead
Assembly
4. Reconnect main input power to the Power Supply and turn the unit ON.
5. Follow set - up directions in the Torch Instruction Manual.
6. Test torch for proper operation.
Connector Pin Layout
#7 / White / Switch
#6 / Green / Switch
A-03511
Hypertherm Adapter Pin Layout (Front View)
#2 / Black / PIP
#3 / Open
#8 / Orange / PIP
#1 / Red / Pilot (+)
#3 / White /
Switch
Small Alignment Slot
Miller Adapter Pin Layout (Front View)
#4, #5 / Negative (-)
Small Alignment Slot
#4, #5 / Negative (-)
#6 / Green / Switch
#2 / Black / PIP
#1 / Red / Pilot (+)
#8 / Orange / PIP
#7 / Open
NOTE
Every effort has been made to provide complete and accurate information in this manual. However, the
publisher does not assume and hereby disclaims any liability to any party for any loss or damage caused
by errors or omissions in this manual, whether such errors result from negligence, accident or any other
cause.