Rear panel, Front panel, Making cable connections – Pioneer PDX-Z9 Manuel d'utilisation
Page 8: Connecting up, Connecting up 02, Chapter 2
Connecting up
02
8
En
Chapter 2
Connecting up
Rear panel
1
AC IN - Power inlet
Connect the supplied power cable (page 11).
2
LINE IN/OUT jacks
Connect an external component. To listen to components
connected to the
LINE IN
jack, press
INPUT
on the
remote control to select
LINE
(page 9).
3
PHONO IN jacks
Connect a turntable. To listen to audio from a connected
turntable, press
INPUT
on the remote control to select
PHONO
(page 9).
4
SIGNAL GND terminal
If your turntable has a grounding wire, connect it here to
reduce undesired sounds (page 9).
5
iPod IN terminal
Connect the provided iPod control cable here
(page 9, 22)
.
6
LAN (10/100) terminal
Use provided LAN cable to connect to network (
page 9
,
21
).
7
AM LOOP antenna terminal
Connect provided AM loop antenna here (page 10).
8
FM antenna socket
Connect provided FM wire antenna here (page 10).
9
SPEAKERS terminals
Connect the speakers here (page 11).
Front panel
1
USB interface
Connect a USB mass storage device for playback
(page 9, 21).
2
F.AUDIO IN jack
To listen to audio from an external component, connect
with a stereo mini-plug cable. Once connected, the input
automatically changes to
FRONT AUDIO IN
(page 9).
Making cable connections
Make sure not to bend the cables over the top of this unit.
This may cause a humming noise from the speakers.
Important
• Before making or changing any connections, switch
off the power and unplug the power cord from the AC
outlet.
AC IN
R
L
R
OUT
LAN
(10/100)
IN
IN
IN
L
SPEAKERS
FM UNBAL 75
LINE
PHONO
SIGNAL
GND
iPod
ANTENNA
AM
LOOP
1
2
3
5
7
8
6
4
9
LAY OFF
USB
SOUND RETRIEVER
PHONES
F. AUDIO IN
1
2
PDX-Z9.book 8 ページ ２００８年２月２６日 火曜日 午後６時３２分