Pioneer PDX-Z9 - Manuel (Page 11)

English
Français
Connecting up 02
11
En
Connecting the speakers
Make sure you connect the speaker on the right to the
right terminal and the speaker on the left to the left
terminal. Also make sure the positive and negative (+/–)
terminals on the receiver match those on the speakers.
You can use speakers with a nominal impedance
between 4
Ω to 8 Ω .
• Connect the speakers to the SPEAKERS terminals
as shown above.
Bare wire connections
Make sure that the speaker cable you’re going to use is
properly prepared with about 10 mm of insulator stripped
from each wire, and the exposed wire strands twisted
together (
fig. A ).
To connect a terminal, unscrew the terminal a few turns
until there is enough space to insert the exposed wire
(
fig. B ). Once the wire is in position, tighten the terminal
until the wire is firmly clamped ( fig. C ).
Important
• Please refer to the manual that came with your
speakers for details on how to connect the other end
of the speaker cables to your speakers.
Caution
• These speaker terminals can be under HAZARDOUS
VOLTAGE . When you connect or disconnect the
speaker cables, to prevent the risk of electric shock,
do not touch uninsulated parts before disconnecting
the power cord.
• Make sure that all the bare speaker wire is twisted
together and inserted fully into the speaker terminal.
If any of the bare speaker wire touches the back panel
it may cause the power to cut off as a safety measure.
Plugging in
Make sure to complete all connections before
connecting to an AC IN inlet.
• Connect the AC power cord to the AC IN inlet on
the rear panel of the receiver, then plug into a
power outlet.
R L
SPEAKERS
FM UNBAL 75 AM LOOP
Right speaker Left speaker
10 mm
fig. A fig. B fig. C
PDX-Z9.book 11 ページ ２００８年２月２６日 火曜日 午後６時３２分