Kolpin 85100 – Universal Independent Rear Suspension Rear Hitch - Manuel (Page 3)

Rev. 5
YAMAHA GRIZZLY
1. Using the 4 U-Bolts provided and the 8 nuts and washers provided attach the Hitch Plate to the
frame of the ATV. See picture below on which holes to use for mounting.
2. Tighten all hardware and make sure hitch is securely attached to the ATV.
YAMAHA GRIZZLY 06-NEWER
1. Remove existing OEM Hitch.
2. Loosen the skid plastic by removing the two rear bolts.
2. You can cut the plastic to go back up around the hitch and reattach. Hitch mounts using the same
application as above.
KAWASAKI BRUTE FORCE
1. Remove existing OEM Hitch.
2. Using the 4 U-Bolts provided and the 8 nuts and washers provided attach the Hitch Plate to the
frame of the ATV. Tighten Securely.
HONDA RINCON
1. Using the holes specified on the hitch drawing, mount hitch using the 2-Spacer Bushings and the
2-3/8”x 5.50” bolts provided.
2. Using the ¾” Bolt and Lock Washer provided, thread the bolt through the existing Honda Ball
Mount and into the threaded bushing on the Kolpin DirtWorks Hitch.
3. Tighten all hardware and make sure the hitch is securely attached to the ATV.
NOTE: Requires Honda Ball Mount.
YAMAHA KODIAK
1. Using the holes specified on the hitch drawing, mount hitch to the ATV using the U-Bolts
provided. Tighten using the washers and nuts provided.
2. Tighten all hardware and make sure the hitch is securely attached to the ATV.