Rs-232c, Media operation control commands – Panasonic AG-DTL1 Manuel d'utilisation

Page 67

Advertising
background image

67

$

Media operation control commands

Data transmitted by PC

Data returned from unit in response

Description of command

[STX] HRE:m [ETX]

Parameter
m = B: BUZZER

E: EJECT
P: REPEAT
R: REWIND
S: STOP

[STX] HRE [ETX]

Sets the unit’s operation mode that is to be established
when the tape-end is reached during recording.
<Note>
This command is not acknowledged while a search control
command is being processed.

[STX] HRL:m [ETX]

Parameter
m = F: Recording enabled

N: Recording disabled

[STX] HRL [ETX]

Sets the lock mode for operation during recording.

[STX] HEA [ETX]

[STX] HEA [ETX]

Sets the operation that is to take place when the EJECT
button is pressed to REW 5 EJECT (tape is ejected after it
has been rewound to its start position).
<Note>
This command is not acknowledged while a search control
command is being processed.

[STX] HEE [ETX]

[STX] HEE [ETX]

Sets the operation that is to take place when the EJECT
button is pressed to EJECT.
<Note>
This command is not acknowledged while a search control
command is being processed.

[STX] HTI:m [ETX]

Parameter
m = A: REWIND5REC

R: REC
S: STOP

[STX] HTI [ETX]

Sets the unit’s operation mode that is to be established
when the tape has been inserted.
<Note>
This command is not acknowledged while a search control
command is being processed.

[STX] HTR:m:b [ETX]

Parameter
m = 0: 2% of tape remaining

1: 10% of tape remaining
2: 20% of tape remaining
3: 30% of tape remaining
F: (OFF) no warning

b = N: Warning is sounded by

buzzer.

F: (OFF) warning is not

sounded by buzzer.

[STX] HTR [ETX]

Sets the remaining tape amount for which REMAIN is to
flash on the display tube as a warning display, and sets the
buzzer to sound when the tape-end position is about to be
reached. (When a 120-minute tape is used)

RS-232C

Advertising