Panasonic AG-DTL1 - Manuel (Page 65)

65
[STX] CRT [ETX] [STX] CRT [ETX] Resets the CTL counter data.
<Note>
This command is not acknowledged while a search control
command is being processed.
[STX] CLP:data [ETX]
Parameter
data = ghmmssff
g = Blank : With a positive (+)
value
– sign : With a negative (–)
value
h = 0—9 : Hours (12-hour
system)
mm = 00—59 : Minutes
ss =
00—59 : Seconds
ff = 00—29 : Frames
[STX] CLP [ETX] Presets a designated counter value on the CTL counter.
<Note>
This command is not acknowledged while a search control
command is being processed or while a tape is being
ejected.
RS-232C
$ Counter control command
Data transmitted by PC Data returned from unit in response Description of command
[STX] CCP:data [ETX]
Parameter
data = ghmmssff
g = Blank : With a positive (+)
value
– sign : With a negative (–)
value
h = 0—9 : Hours (12-hour
system)
mm = 00—59 : Minutes
ss =
00—59 : Seconds
ff = 00—29 : Frames
[STX] CCP [ETX] Presets a designated counter value on the CTL counter.
<Note>
This command is not acknowledged while a search control
command is being processed or while a tape is being
ejected.