Troubleshooting, General, English italiano français – Pioneer S-DV990ST Manuel d'utilisation

Page 83: Nederlands, Español deutsch, Additional information 13

Advertising
background image

Additional information

13

83

En

English

Italiano

Français

Nederlands

Español

Deutsch

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie
in another component. Investigate the other components and electrical appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest
Pioneer authorized service center or your dealer to carry out repair work.

• If the system does not operate normally due to external effects such as static electricity

disconnect the power plug from the outlet and insert again to return to normal operating
conditions.

General

Problem

Remedy

The power does not
turn on.

• Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the rear
panel. This could cause the system to shut off automatically.

No sound is output
when a function is
selected.

• If you’re using the line input, make sure the component is connected
correctly (see

Connecting auxiliary components

on page 73).

• Press

MUTE

on the remote control to turn muting off.

• Adjust the

VOLUME

.

• If you’re using the TV input, make sure you’ve selected the RCA audio
input (see

Switching the TV audio input to SCART or RCA

on page 76).

No image is output
when playing discs.

• Make sure the TV is connected correctly (refer to the Setup Guide).

No sound from
surround or center
speakers.

• Refer to

Setting the channel levels

on page 61 to check the speaker levels.

• Check that you haven’t selected the

STEREO

sound mode (see

Listening

in surround sound

on page 30).

• Check that the Virtual mode is not on (

Using the Advanced Surround

effects

on page 32).

• Connect the speakers properly (refer to the Setup Guide).

Can’t operate the
remote control.

• Replace the batteries (refer to the Setup Guide).
• Operate within 7 m, 30° of the remote sensor on the display unit (refer to
the Setup Guide).
• Remove any obstacles or operate from another position.
• Avoid exposing the remote sensor on the display unit to direct light.

No display

• Make sure everything is connected properly.

HTS.book 83 ページ 2003年4月28日 月曜日 午後8時0分

Advertising
Ce manuel est liée aux produits suivants: